More Views

Me Infrared Receiver Decode

Rs 1,190.00

Have you used this product?
Rate it now.

13005

By buying this product you can collect up to 119 loyalty points. Your cart will total 119 points that can be converted into a voucher of Rs 23.80.


The Makeblock Me series modules are designed to be simple to wire, easy to program, the controller is compatible with Arduino, each Me-modules comes with an Arduino library for easy programming.Me Infrared  Receiver Decode module is designed for receiving infrared signals and controlling the robotics from the infrared remote control.

More details

         
Me Infrared Receiver Decode
Rs 1,190.00

Other Specifications
Dimension(L*W*H) 2.4cmx4.8cm

Disclaimers:

  1. Specifications are subject to change without notice. Please call or write to us in case you would like to be doubly sure. For material which is not as per specifications, full refund is possible within 3 days of delivery or free replacement is available within 30 days of purchase.
  2. Press on to expand and to collapse the rows.

No customer comments for the moment.

Write your review

Me Infrared Receiver Decode

Me Infrared Receiver Decode

The Makeblock Me series modules are designed to be simple to wire, easy to program, the controller is compatible with Arduino, each Me-modules comes with an Arduino library for easy programming.Me Infrared  Receiver Decode module is designed for receiving infrared signals and controlling the robotics from the infrared remote control.

Write your review

NO registration required!

If the question you have has not yet been answered here, use the form below to ask something about this addon.

(optional)
*(Required to be notified when an answer is available)
Send question!
  • Better decoder solution than V2.0
  • Simple control by using a IR control under NEC IR protocol
  • Comes with Arduino library for easy programing
  • Over-current protection
  • Easy wiring with 6 Pin RJ25 interface
  • Labeled with blue tag and compatible with Me Baseboard
  • 2.54mm breakout pins for connecting with jumper wires
  • 16mm interval M4 mounting holes, compatible with Makeblock beams
  • Two on board indicator LEDs for  debugging and feedback
Robo finder